Designed with quality in mind, Intermatica(tm)s 24-Volt valve actuators provide reliable control of 2-way and 3-way diverter valves for pool/spa combinations and water features. The water flow can be altered for specific applications through the adjustable cam, which rotates diverter valves to multiple degree settings. The cam settings can be easily adjusted by simply removing the lid. These valve actuators are compatible with all pool/spa valves currently offered in the industry and will retrofit into all pool/spa control systems. \n\n FROM THE MANUFACTURER \n Designed with quality in mind, Intermatica(tm)s 24-volt valve actuators provide reliable control of 2-way and 3-way diverter valves for pool/spa combinations and water features. The water flow can be altered for specific applications through the adjustable cam, which rotates diverter valves to multiple degree settings. The cam settings can be easily adjusted by simply removing the lid. These valve actuators are compatible with all pool/spa valves currently offered in the industry and will retro fit into all pool/spa control systems.
|
Mechanical hi-limits & thermostats from Eaton's Crouse-Hinds Division are ran at 50/60hz and are used for heavy duty line voltage to control fan coils, motor starters, valves, contactors and circulator motors in heating and/or cooling systems.
|
Balboa Water Group Transformer. Used on Balboa Duplex 115v circuit boards/systems.
|
Field adjustable vacuum switch. Dual vacuum
switches available, factory set to allow each microswitch to operate at a different water vacuum setting. Range is 10% to 25% lower on reducing vacuum. Special differentials available. |
Mechanical hi-limits & thermostats from Eaton's Crouse-Hinds Division are ran at 50/60hz and are used for heavy duty line voltage to control fan coils, motor starters, valves, contactors and circulator motors in heating and/or cooling systems.
|
Balboa Water Group Transformer. Used on Balboa Duplex 230v circuit boards/systems.
|
Diehl 24 hr spa time clock. Diehl 800 series electromechanical time clock TA4079 is a 120V, 15amp panel mount timer for bath, whirlpool, spa and hot tub controls. 5 terminal tabs on the bottom on this SPDT timer. Red colored bezel behind timer dial.
|
Presair air switches deliver complete electrical isolation with zero voltage at the point of actuation. The air switching system connects the air switch to an air bellow using air tubing. When the air bellow is pressed, it sends a pulse of air through the tubing actuating the air switch. The Tinytrol Miniature Air Switch is available in both single and double pole, with alternate and momentary action. Presair's air switching system is commonly used in pool and spa application, home appliances, medical applications, and many others!
|
Since the mid 1980's the Harwil Q-12 flow switch has been used by some of the largest companies in the Pool & Spa and fluid control industries. The Q-12 has several factory adjustable
parameters that provide the flexibility to meet the requirements of almost any application. The Q-12 verifies fluid flow, typically in conjunction with another device. For example most of swimming pool salt chlorine generators use the Q-12 to verify sufficient flow before the generator is energized. In a spa or hot tub the Q-12 ensures sufficient flow to prevent the water heater from a meltdown. In a chiller the Q-12 prevents the system from freezing. At home the Q-12 turns on the water disinfection system when someone is getting a glass of water. |
Mechanical hi-limits & thermostats from Eaton's Crouse-Hinds Division are ran at 50/60hz and are used for heavy duty line voltage to control fan coils, motor starters, valves, contactors and circulator motors in heating and/or cooling systems.
|
Monitors Water Flow to prevent damage due to overheating. Activates a visual or audible device immediately whenever raw water flow is stopped or impeded is a two wire, non- polarity switch that is Normally Closed (Normally Open available) and opens at 6 to 8 GPM of raw water flow. It stays open until flow slows or ceases and then actives any audible or visual alarm.
|
|
Monitors Water Flow to prevent damage due to overheating. Activates a visual or audible device immediately whenever raw water flow is stopped or impeded is a two wire, non- polarity switch that is Normally Closed (Normally Open available) and opens at 6 to 8 GPM of raw water flow. It stays open until flow slows or ceases and then actives any audible or visual alarm.
|
Tecmark Series ETS1000 Electronic Thermostats are temperature regulating devices specifically designed around rigorous parameters. The Series ETS thermostats integrate a solid state thermistor to an electronic comparator circuit for accurate temperature control. All input and output connections are made via 1/4" male quick connect terminals. The Series ETS are transient protected and provide fail-safe operation if the sensor wires are severed or shorted. They are designed and engineered to exceed 100,000 cycles under full mechanical, electrical and thermal loads.
|
|
Presair air switches deliver complete electrical isolation with zero voltage at the point of actuation. The air switching system connects the air switch to an air bellow using air tubing. When the air bellow is pressed, it sends a pulse of air through the tubing actuating the air switch. The Tinytrol Miniature Air Switch is available in both single and double pole, with alternate and momentary action. Presair's air switching system is commonly used in pool and spa application, home appliances, medical applications, and many others!
|
|
|
T91 Style, mini power relay by Zettler. 40 Amp switching capability. Circuit board mount relay. Versatility of both PC and "Trace-Saver" quick-connect terminals on contacts.
|
|
|
Mechanical hi-limits & thermostats from Eaton's Crouse-Hinds Division are ran at 50/60hz and are used for heavy duty line voltage to control fan coils, motor starters, valves, contactors and circulator motors in heating and/or cooling systems.
|
Mechanical hi-limits & thermostats from Eaton's Crouse-Hinds Division are ran at 50/60hz and are used for heavy duty line voltage to control fan coils, motor starters, valves, contactors and circulator motors in heating and/or cooling systems.
|
|
Mechanical hi-limits & thermostats from Eaton's Crouse-Hinds Division are ran at 50/60hz and are used for heavy duty line voltage to control fan coils, motor starters, valves, contactors and circulator motors in heating and/or cooling systems.
|
|
|
|
|
|
The FM1 series timer modules are designed to be integrated inside of a machine control panel, circuit board, or other equipment. They are a simple and low cost alternative for applications that do not require more than 21 A or 2 HP, 240 VAC. The FM1 is designed for 24-hour or 7-day control or overriding a functional typical state of a heating, ventilation, refrigeration, lighting, security, or pump system. The FM1 series is ideal for 12, 24 VAC/VDC,120 or 208/240VAC single-phase general applications.
|
|
|
|
|
Copyright © 1999-2024 BuilderDepot, Inc. Site Designed and Maintained by Inline Internet Systems, Inc. |