- Transmitter Type: ET - Carbon Compatible Electret element designed into a amplified circuit to act as a Carbon without variations
- Output Level: -23 dBV - Output Impedance: 20 - Output Minimum (-20 dBV drive): 96 dBSPL - Input Impedance: 150 Ohm - Amplitude Limiting: 124 dBSPL - Receive distortion: less than 5% - Compatible with hearing aids - PTT handsets do not require a hook switch in cradle - G-Style / 500-Style Round Receiver & Transmitter Ends - Connector: 4 conductor modular jack (RJ22) - Compatible with Cortelco 2500 and 2554 series telephones |
- Push-to-Signal (PTS) Initiates radio signal transmission
- The PTS is for radios, FAA, dispatch consoles or where 6-conductor cord is required - M: Modular Jack, for RJ11 6-Wire plugs. OP Cord not included. - CRBN: Carbon Transmitter - 8 Volts DC |
- OP3 - 9 Foot coil cord, hardwired with a dual prong plug CRBN - Carbon Transmitter - 8 Volts DC
- Push-to-Signal (PTS) Initiates radio signal transmission - The PTS is for radios, FAA, dispatch consoles or where 6-conductor cord is required |
- Amplified Handset
- Hearing aid compatible - Noise cancelling is available - Push-to-signal (PTS) Initiates radio signal transmission - Makes listening easier in environments with intermittent background noise - For radios, FAA, dispatch consoles, or where 6-conductor cord is required. |
- Push-to-Signal (PTS) Initiates radio signal transmission
- The PTS is for radios, FAA, dispatch consoles or where 6-conductor cord is required - CRBN - Carbon Transmitter - 8 Volts DC |
- Walker push-to-talk handset
- Secure in environments where background conversations must not be overheard on the telephone - Effective in environments with loud background noise - Compatible with hearing aids - EM-80 standard gain electret transmitter |
- Amplified handset
- For use with Panasonic PBX systems - No cord included - Rotary volume wheel located on handset - Distorion free amplifier - Excellent for noisy environments, weak connections, and the hearing impaired - "K" style handset, type2 (with a modular plug receptacle) - Hearing aid compatible - Nominal gain of 20dB for incoming sound - Not compatible with the KX-DT series phones - Pearl |
- Amplified receiver handset represents the premier line of amplification handsets
- Provide increased volume to the incoming sound of gain under a variety of conditions - Amplified version designed to work on carbon compatible phone systems |
- NC/244 Handset
- Amplified Noise Canceling |
- Includes pre-installed noise canceling microphone, which reduces sidetone noise up to 80%
- Does not require hook switch in the cradle - Round receiver and transmitter ends - RJ22 4 conductor connector - Compatible with Cortelco 2500 and 2554 series telephones |
- Walker in-line receiver amplifier
- Makes low volume - Compatible with electronic and standard telephone - Complete with plug-in power supply - Easy to install - Installs between the handset and telephone - Rotary volume control numbered 1-9 - Users with normal hearing should not go above 3 - Improves volume up to 20dB - Do not connect directlyto a telecommunication network |
- Walker in-line receiver amplifier
- Makes low volume - Compatible with electronic and standard telephone - Complete with plug-in power supply - Easy to install - Installs between the handset and telephone - Rotary volume control numbered 1-9 - Users with normal hearing should not go above 3 - Improves volume up to 20dB - Do not connect directlyto a telecommunication network - Ivory w/ blackrotary control W10 |
- In-line receiver amplifier
- Makes low volume - Compatible with electronic and standard telephone - Complete with plug-in power supply - Easy to install - Installs between the handset and telephone - Rotary volume control numbered 1-9 - Users with normal hearing should not go above 3 - Improves volume up to 20dB - Do not connect directlyto a telecommunication network |
- Push-to-Signal (PTS) Initiates radio signal transmission
- The PTS is for radios, FAA, dispatch consoles or where 6-conductor cord is required - CRBN - Carbon Transmitter - 8 Volts DC |
- Push-to-Signal (PTS) Initiates radio signal transmission
- The PTS is for radios, FAA, dispatch consoles or where 6-conductor cord is required - NC-1 - Noise canceling mic, carbon compatible. Reduces background noise by 3 to 4 decibels - OP3 - 9 Foot coil cord, hardwired with a dual prong plug - CRBN - Carbon Transmitter - 8 Volts DC |
Handset Push-To-Signal (PTS) with noise canceling microphone for 6-wire applications such as 2-way radio dispatch, 911 centers, emergency operations, FAA, control towers
|
TALK/RING/MONITOR switch conveniently located inside handgrip
Switchable tone or pulse dialing, with switch located inside of handgrip High impedance monitor will not disturb data, conversations, or signaling Polarity indicator Last number redial (31 digits maximum) 10 number memory storage Three position volume control for up to 12 dB gain Protection against excessive voltage and transient ringer signals Direct connection to most batteries and power supplies Spring-loaded reversible belt clip Cloth-covered cord equipped with securely anchored strain relief, modular RJ11X plug, and two five-way test clips Spade connector included Moisture resistant 2.5 mm headset jack compatible |
- Clear static-free reception
- Electret transmitter provides extra-clear voice - Hearing aid compatible - Charcoal color - Works with all Cisco 78xx, 88xx and DX600 series phones - Not compatible with Cisco 79xx models. See Clarity WS-2620-24 Cisco Phone 7900 Push-To-Talk Handset instead - Not compatible with Cisco 6900, 8900, 9900, Use Clarity Walker WS-2800 Cisco Phone 6900 8900 9900 PTT Handset instead |
- W6 handset has an amplified receiver controlled by a rotary (thumb wheel) volume control
- Electronic circuitry is completely contained in the handset - Improve listening volume up to 20 dB for clearer reception - Add receiver volume in noisy surroundings,poor line quality and for the hearing impaired - Includes a carbon compatible transmitter for clear transmission and are hearing aid compatible - Volume level is fixed until the thumb wheel is rotated - Quick and easy installation û the Walker W6 amplified handsets simply replace your old handset |
- Handset 6" Coiled Cord
- Black - Modular RJ9 (Small, RJ11) for standard handsets - Heavy Duty PVC Flat Coiled |
- Walker push-to-talk handset
- Secure in environments where background conversations must not be overheard on the telephone - Effective in environments with loud background noise - Compatible with hearing aids - EM-80 standard gain electret transmitter - Black |
- Amplified Handset for added receiver volume in noisy surroundings, poor line quality, and for the hearing impaired
- Universally compatible with carbon, electret or dynamic transmitters - Compatible with virtually any telephone with a K-style handset. - Solves compatibility issues and simplifies ordering - Noise canceling - Hearing aid compatible - AC powered amplified handset - Improve listening volume up to 20dB for clearer reception |
- Amplified handset
- For use with Panasonic PBX systems - No cord included - Rotary volume wheel located on handset - Distortion free amplifier - Excellent for noisy environments, weak connections, and the hearing impaired - "K" style handset, type2 (with a modular plug receptacle) - Hearing aid compatible - Nominal gain of 20dB for incoming sound - Not compatible with the KX-DT series phones - Black |
- Volume control
- Quick and easy installation - Noise canceling microphone - Electret Microphone Element |
- WalkerÆs W7 amplified transmitter handset improves a variety of transmission problems: poor connections, talking to a person with a hearing loss, or for speech impaired users.
- Solid state, self-contained amplifier can be set to the ideal level for any application. - Outgoing speech level can be increased up to 18 dB gain, three times the normal level. - Rotary thumb wheel volume control is conveniently located for fingertip control. - W7 is also available with the NoiseCensor« transmitter for use in noisy environments. |
Clarity / Walker 15Æ 6 wire handset cable
|
Handset with armored cord
|
- Plantronics noise cancelling censor for handset
- Noise cancelling system uses directional microphone housing - Reduces side tones - Makes calls clearer - Usable with amplified handsets - Converts existing handset into noise cancelling handset |
- Plantronics noise cancelling censor for handset
- Noise cancelling system uses directional microphone housing - Reduces side tones - Makes calls clearer - Usable with amplified handsets - Converts existing handset into noise cancelling handset |
- Push-to-Mute (PTM) Disengages (mutes) the transmitter
- Carbon Compatible - Electret element designed into a amplified circuit to act as a Carbon without variations |
|
|
|
|
Copyright © 1999-2024 BuilderDepot, Inc. Site Designed and Maintained by Inline Internet Systems, Inc. |